• Bus-powered CO2, temperature and humidity sensors • Wall mounting • CO2 measuring range: 0 to 2000 ppm • Temperature measuring range: -20 to 50 °C • Humidity measuring range: 0 to 100 %RH • LCD Display for showing measured values • Touch function to activate back-lighting and change signal type • Low current consumption • Easy installation • Smart Dupline® protocol
By buying this product you can collect up to 40
loyalty points.
Your cart will total 40
points that can be converted into a voucher of
20,00 kr.
• Bus-powered CO2, temperature and humidity sensors • Wall mounting • CO2 measuring range: 0 to 2000 ppm • Temperature measuring range: -20 to 50 °C • Humidity measuring range: 0 to 100 %RH • LCD Display for showing measured values • Touch function to activate back-lighting and change signal type • Low current consumption • Easy installation • Smart Dupline® protocol
• Bus-powered CO2, temperature and humidity sensors • Wall mounting • CO2 measuring range: 0 to 2000 ppm • Temperature measuring range: -20 to 50 °C • Humidity measuring range: 0 to 100 %RH • LCD Display for showing measured values • Touch function to activate back-lighting and change signal type • Low current consumption • Easy installation • Smart Dupline® protocol
Product Description
The SHSUXXXXD line are bus-powered room sensors for wall-mounting. They are available in different combinations of CO2, temperature and relative humidity. The sensors have a LCD display for showing the measured values. By activating the touch button in the front the LED backlight is turned on and the signal type to be shown can be changed. The only connection needed for the sensor is the Dupline® 2-wire cable. Several sensors can be multi-dropped via the same Dupline® 2-wire bus, thereby simplifying the wiring to the controller significantly. The address assignment and the setup of the display operating mode are performed over the bus by using the SBWEB/SHWEB PC-based programming tool.
Touch button
• When the touch button in the front is activated the LCD display turns on with backlighting. • When activated again the display changes to show the next signal. • Backlighting switches off after 30s without activations and the home variable is shown. • The “home signal” is selectable by configuration tool • The time-out period is selectable by configuration tool
For Controller UWP 3.0 - SH2WEB24 - SB2WEB24 - SA2WEB24
Address assignment Automatic: the controller recognises the module through the SIN (Specific Identification Number) UWP 3.0 og Sx2WEB24
Protection IP20
Beskyttelsesgrad 2 (IEC 60664-1, par. 4.6.2)
Operating temperature -20° til +50°C
Storage temperature -40° til +70°C
Humidity (non-condensing) 0 - 90%
Datasheet / Manual Download Data Sheet / Manual - click on the tab Download