• Bus-powered CO2, temperature and humidity sensors • Wall mounting • CO2 measuring range: 0 to 2000 ppm • Temperature measuring range: -20 to 50 °C • Humidity measuring range: 0 to 100 %RH Only SHSUCOTHL • “Traffic light LED indication” for CO2 level • Low current consumption • Easy installation • Smart Dupline® protocol
By buying this product you can collect up to 35
loyalty points.
Your cart will total 35
points that can be converted into a voucher of
17,50 kr.
• Bus-powered CO2, temperature and humidity sensors • Wall mounting • CO2 measuring range: 0 to 2000 ppm • Temperature measuring range: -20 to 50 °C • Humidity measuring range: 0 to 100 %RH Only SHSUCOTHL • “Traffic light LED indication” for CO2 level • Low current consumption • Easy installation • Smart Dupline® protocol
• Bus-powered CO2, temperature and humidity sensors • Wall mounting • CO2 measuring range: 0 to 2000 ppm • Temperature measuring range: -20 to 50 °C • Humidity measuring range: 0 to 100 %RH Only SHSUCOTHL • “Traffic light LED indication” for CO2 level • Low current consumption • Easy installation • Smart Dupline® protocol
Product Description
The SHSUXXXXL line are bus-powered room sensors for wall-mounting. They are available in different combinations of CO2, temperature and relative humidity. The sensors have a “traffic light” LED which is used to indicate the CO2 level in green, amber or red colour. The only connection needed for the sensor is the Dupline® 2-wire cable. Several sensors can be multi-dropped via the same Dupline® 2-wire bus, thereby simplifying the wiring to the controller significantly. The address assignment and definition of CO2 threshold levels are performed over the bus by using the SBWEB/SHWEB PC-based programming tool.
RGB LED
By means of the SBWEB/SHWEB configuration tool it is possible to set the CO2 thresholds (green to yellow and yellow to red) to automatically light the LED in green, yellow or red colour depending on CO2 level.
For Controller UWP 3.0 - SH2WEB24 - SB2WEB24 - SA2WEB24
Address assignment Automatic: the controller recognises the module through the SIN (Specific Identification Number) UWP 3.0 og Sx2WEB24
Weight 150 g
Failsafe mode Hvis SH2MCG24 mister kommunikationen med SH2WEB24, slukker Dupline®- udgangen. I den situation vil alle moduler der er tilsluttet bussen gå i den fejlsikre tilstand der er programmeret individuelt med SH-værktøjet.
Protection IP20
Beskyttelsesgrad 2 (IEC 60664-1, par. 4.6.2)
Operating temperature -20 to +50°C (-4 to +122°F)
Storage temperature -40 to +70°C (-40 to + 158°F)
Humidity (non-condensing) 0 til 90% Rh
Datasheet / Manual Download Data Sheet / Manual - click on the tab Download
DIM.: (h x w x d) 80 x 90 x 26 mm
Color white
Information Temperature Signal range -20 to 50 °C
Information 2 Temperature Signal range -20 to 50 °C Inaccuracy +/-0,5°C