Smart House Solution Danmark

Search on blog

Smart House UWP

Home

Home

Home

Home

Dimmer switch 2 x 1-10 V for fitting m. Hf connection

1

Dimmer switch 2 x 1-10 V for fitting m. Hf connection

By buying this product you can collect up to 17 loyalty points. Your cart will total 17 points that can be converted into a voucher of 8,50 kr.


BH4-D10V2-230

 

Switching and dimming of adjustable ballast, 1-10V

More details

BH4-D10V2-230

  • BH4-D10V2-230

    MODE OF OPERATION
    Coding

    By programming unit GAP 1605 each activation channel assigned any address between A1 and P8 via module connector on the front of the dimmer. Channel distribution is as follows: Functions which are not to be used should not be coded. The coding of the dimmer can be carried out without either supply voltage or Dupline signal. The preserved permanently, but can be overwritten as needed. Dimmer outputs are configured at the factory in such a way that the disabled in the event of an error. This configuration can also be changed using GAP 1605. Option 1 causes the lighting to 100% in case of an error while setting 0 disables the dimmer outputs (default setting). Commissioning Commissioning must be performed by an authorized, trained technician. Follow the connection diagram during installation. All lines to be connected must be dead. The following table shows the breakdown of the terminals: Connection between Dupline signal and earth potential will cause malfunctions and are not permissible. It is important that the supply voltage and Dupline signal has the correct polarity. To meet the requirements for protective VDE 0100 part 410 are respected and applied during installation. LED indication Status of the device indicated by LEDs, which are mounted on the front.

    • For Controller BH8-CTRLX - BH8-CTRLZ - G3800xx01x
    • Also compatible with ..: Can be used on a UWP 3.0 og Sx2WEB24 Check with a SH2DUG24 Dupline-Generator
    • Address assignment BGP-COD-BAT
    • Adressedeling. If used the same with SH2DUG24 - Read the Dupline HW manual for Compatibility mode
    • Weight 400g
    • Protection IP20
    • Forside IP50
    • Screw terminal IP 20
    • Beskyttelsesgrad 2 (IEC 60664-1, par. 4.6.2)
    • Operating temperature 0° til +50°C
    • Storage temperature -20 - +85 °C
    • Humidity (non-condensing) 20 til 80% RH
    • House Dimensions 2-DIN-modul
    • Mounting DIN-skinne
    • DIM.: H4 Hus
    • Power supply Forsyning Bestillingsnr. 230 VAC

    Reviews

    Write a review

    Dimmer switch 2 x 1-10 V for fitting m. Hf connection

    Dimmer switch 2 x 1-10 V for fitting m. Hf connection

    BH4-D10V2-230

     

    Switching and dimming of adjustable ballast, 1-10V

    Write a review

    4 other products in the same category: