OPUS PIR sensor. Distance up to 6 m, 90º. Fitted in the OPUS products, white.
BOW-PIR90 is a one-channel mono stable sending with a PIRsensor which works by using
a two-piece detector. The transmitter is activated if the temperature suddenly changes (most often
due to heat radiation from a person) relative to background radiation. therefore,
transmitter used for ON / OFF switching of lighting, air conditioning etc.. If someone
moves into a sensing area, activated BOW-PIR90. PIR sensor is designed for installation in a standard switch height. Slow movements between zones resulting in a detection speed of less than 5 pulses / sec. undetected. Nor rapid movements
which provides a detection of more than 5 pulses / sec. will be discovered. Since BOWPIR90 is a passive device, you can place multiple sensors in the same room without interfering
each other. Walk test: the diode reacts to any channel coded on I / O2.
If the diode is programmed on the same channel as PIRindgangen on I / O 1, the transmission
follow the diode. The LED turns on when Piren is activated. The module should not be installed as
b) In places exposed either to sunlight or to motor vehicle headlights.
c) In places exposed to direct air flow from a heater or air conditioner.
d) In places exposed to rapid temperature changes.
e) In places exposed to severe vibration.
f) Close to glass or similar things which can reflect the infrared radiation.
g) the alarm system.
For Controller BH8-CTRLX - BH8-CTRLZ - G3800xx01x
Also compatible with ..: Can be used on a Sx2WEB24 Check with a SH2DUG24 Dupline-Generator
Address assignment BGP-COD-BAT
Weight 50 g
Beskyttelsesgrad 3 (IEC 60664)
Operating temperature -20° til +50°C
Storage temperature -50° til +85°C
Humidity (non-condensing) 20 til 80% RH
House Dimensions 66 x 66 Opus
Datasheet / Manual Download Data Sheet / Manual - click on the tab Download