Output Module 4 x 20 Amp

BH8-RE20A4-230

4-channel receiver with 4 normally open contact outputs. Each output

is individually coded by means of the code programmer

BGP-COD-BAT. For changing the default setting, please refer to the

datasheet on BGP-COD-BAT. The outputs are normally OFF.

When a transmitter coded to the selected channel is activated, the

output turns ON and remains ON until the respective channel

becomes deactivated. The default setting is such that upon loss of

smart-house carrier all the outputs go OFF. If fail polarity is set to 1,

the relays will go on upon loss of carrier.

On the front of the module, it is possible mechanical to override

each relay. The LEDs will not follow manual override. The manual

override will be reset if smarthouse or power is put off and on

in min. 10 sec. Each relay is labled so it is possible to see the

relays actual status.

Note:

At delivery some of the relays might be ON due to transportation

bumps. To be sure that the relays are OFF, connect the

module to power and smarthouse and transmit on channels

A1-4 once.

Note:

Due to the construction with bistable relays, the

module is intended for heating and light control only.

• For Controller BH8-CTRLX - BH8-CTRLZ - G3800xx01x
• Also compatible with ..: Can be used on a UWP 3.0 og Sx2WEB24 Check with a SH2DUG24 Dupline-Generator
• Address assignment BGP-COD-BAT
• Weight 500g
• Protection IP20
• Beskyttelsesgrad 3 (IEC 60664)
• Operating temperature -5 to +50°C (+23° to +122°F)
• Storage temperature -50 to +85°C (-58° to +185°F)
• Humidity (non-condensing) 20 til 80% RH
• Datasheet / Manual Download Data Sheet / Manual - click on the tab Download
• Mounting DIN-skinne
• DIM.: H8 Hus

• bh8-re20a4-230 ds_eng.pdf
  
  
• bh8-re20a4-230 ds_no.pdf
  
  
• bh8-re20a4-230.jpg
  
  
• bh8-re20a4-230 ds_spa.pdf