4-channel receiver with four normally open contact outputs. Each output is encoded individually via code programming device BGPCOD-BAT. changing the factory setting are described in the data sheet for BGP-COD-BAT.
The outputs are normally disabled. When a transmitter is tagged to the selected channel, is activated, activate the exit. End remains activated until the pagaldende channel again will be disabled. The factory setting is made as follows, that if the smart house barebolgen is lost, turn off all outputs. Bemark: upon delivery, some of relaerne item enabled pga. vibrations during transport. In order to ensure that relaerne have been disabled, the module is connected to the supply and Dupline, and then to be sent once the pa channel A1-4. Bemark: Pa because of the design of bistable relaer module is intended only for management of heat and light.
For Controller BH8-CTRLX - BH8-CTRLZ - G3800xx01x
Also compatible with ..: Can be used on a UWP 3.0 og Sx2WEB24 Check with a SH2DUG24 Dupline-Generator
Address assignment BGP-COD-BAT
Weight 400g
Protection IP20
Beskyttelsesgrad 3 (IEC 60664)
Operating temperature -5 - +50°C
Storage temperature -50° til +85°C
House Dimensions H4 bus
Datasheet / Manual Download Data Sheet / Manual - click on the tab Download