Udgangs modul 8 ( 2x4 ) relæer 230 VAC

BH4-RE16A8-230

8-channel receiver
Relay load: 16A
Module-load: 32A (16A per relay team)
Galvanic separated SPST relay outputs
For mounting on DIN rail (EN 50022)
LED indications for power supply, smart house carrying signal and outputs

8-channel receiver with eight normally open contact outputs. Each output is adjusted by using the programming device BGPCOD-BAT. To change the default settings, Please see the data sheet for the BGP-COD-BAT.

The outputs are usually on OFF When a transmitter, which is set to the selected channel is activated, go end at ON and will be here until the channel is disabled.

The receiver is set by default to all outputs go on OFF If the smart-house-signal  falling out.

Note: upon delivery, some of the relays have gone ON during transport. In order to be sure that the relays are on the OFF, you should connect the module and send a signal once on channels A1-8.

Note: due to the construction of flop-relay module is intended only for heating and lighting control.

• For Controller BH8-CTRLX - BH8-CTRLZ - G3800xx01x
• Also compatible with ..: Can be used on a UWP 3.0 og Sx2WEB24 Check with a SH2DUG24 Dupline-Generator
• Address assignment BGP-COD-BAT
• Weight 400g
• Protection IP20
• Beskyttelsesgrad 3 (IEC 60664)
• Operating temperature -5 til +50°C (+23° til + 122°F)
• Storage temperature -50 til +85°C (-58° til + 185°F)
• Humidity (non-condensing) 20 til 80% RH
• House Dimensions H4 Hus
• Datasheet / Manual Download Data Sheet / Manual - click on the tab Download
• Mounting DIN-skinne

• bh4-re16a8-230 ds_no.pdf
  
  
• bh4-re16a8-230 ds_spa.pdf
  
  
• bh4-re16a8-230 ds_dan.pdf
  
  
• bh4-re16a8-230 ds_eng.pdf
  
  
• bh4-re16a8-230 ds_sv.pdf
  
  
• bh4-re16a8-230.jpg