BOW-WLS4 Smart-house sensor for applications for building automation 4 individually programmable pushbutton inputs Channel programming with BGP-COD-BAT Wall mounting Range up to 100 meters in open air 3 V battery supply (CR2032) Battery life up to 5 years under normal use
By buying this product you can collect up to 8
loyalty points.
Your cart will total 8
points that can be converted into a voucher of
4,00 kr.
BOW-WLS4 Smart-house sensor for applications for building automation 4 individually programmable pushbutton inputs Channel programming with BGP-COD-BAT Wall mounting Range up to 100 meters in open air 3 V battery supply (CR2032) Battery life up to 5 years under normal use
The BOW-WLS4 is designed for base unit BH4-WBU-230 and works only with this.
The wireless switches BOW-WLS4 programmed as standardafbrydere, with a BGP-COD-BAT (see data sheet for this).
Communication between circuit breakers BOW-WLS4 and BH4-WBU-230 is created as follows
manner:
- Press the Mode button on the base BH4-WBU-230, until the red LED that indicates Association, lights.
- Press the push button (switch module) BOW-WLS4 as desired associated (associate) to the base
BH4-WBU-230 base. Once the association is complete illuminates all 4 LEDs briefly up (about 1 sec.).
If the association fails as a result of such. that distance is exceeded, all LEDs in the switching module light up simultaneously in approximately 500 msec. The same will happen if under ordinary circumstances can be no connection between the BH4-WBU-230 and switching modules BOW-WLS4.
It is possible to disable (stop) communication between base BH4-WBU-230 and all the modules which it is affiliated. - Press mode on the base BH4-WBU-230 until the red LED
Disable lights
Thus there is no connection between the BH4-WBU-230 and its associations.
To reestablish the connection, push mode until either Associate or Deactivate
lights.
Under normal circumstances, the LEDs Supply and Dupline continuously while LED
for communication only flashes briefly when pressing an associated interrupt BOWWLS4.
LEDs always follow the push button and can not be programmed individually or
removed.
The LED is a confirmation of that communication is managed.
For Controller BH8-CTRLX - BH8-CTRLZ - G3800xx01x
Also compatible with ..: Can be used on a UWP 3.0 og Sx2WEB24 Check with a SH2DUG24 Dupline-Generator
Address assignment BGP-COD-BAT
Adressedeling. If used the same with SH2DUG24 - Read the Dupline HW manual for Compatibility mode
Weight 50 g
Protection IP20
Forside IP50
Screw terminal IP 20
Beskyttelsesgrad 3 (IEC 60664)
Operating temperature 0° til +50°C
Storage temperature -20° til +70°C
Humidity (non-condensing) 20 til 80% RH
House Dimensions 66 x 66 Opus
Datasheet / Manual Download Data Sheet / Manual - click on the tab Download