Output module 8 ( 2×4 ) relays 230 VAC

BH4-RE16A8-230

8-channel receiver
Relay load: 16A
Module load: 32A (16A per relay group)
Galvanically isolated SPST relay outputs
For mounting on DIN rail (EN 50022)
LED indications for power supply, smart-house carrier signal and outputs

8-channel receiver with eight normally open contact outputs. Each output is set using the BGPCOD-BAT programming device. To change the default settings, please see the BGP-COD-BAT data sheet.

The outputs are normally OFF When a transmitter – which is tuned to the selected channel – is activated, the output goes ON and remains here until the channel is deactivated.

By default, the receiver is set so that all outputs go to OFF if the smart-house signal drops out.

Note: On delivery, some of the relays may have switched ON during transport. To be sure that the relays are OFF, you should connect the module and send a signal once on channels A1-8.

Note: Due to the construction with bistable relay, the module is only intended for heat and light control.